Test the freight elevator every day to see if the freight elevator can operate normally.
The elevator is a kind of elevator equipment composed of traveling mechanism， hydraulic mechanism， electric mechanism and supporting mechanism. The hydraulic oil is under a certain pressure formed by the vane pump， and enters the lower end of the hydraulic cylinder through the oil filter explosion-proof electromagnetic reversing valve， throttle valve， hydraulic control check valve， and balance valve， so that the upward movement of the hydraulic cylinder can lift heavy objects ， and the rated pressure relief valve is adjusted， and the pressure gauge reads the pressure gauge.
Heilongjiang: High-pressure water abrasive derusting. Using the impact of high-pressure water jets and abrasives to polish and remove rust on the screw elevator， the advantage is that the damage to the material is small， but the water has certain damage to the electronic equipment and it is suitable for the detachable type of screw elevator.
In the construction elevator， the switch box also has leakage protection equipment. Its wires and cables are well insulated， without leakage， and the metal threaded is not rusted， and its damage is close to zero. His steel wire rope should comply with the corresponding configuration requirements， and there is no problem of broken strands and diameter reduction. Of course， the number of broken wires should not exceed the corresponding standard. His pulley movement is very flexible.
Maroua It is best not to cover the aerial work vehicle and park the vehicle outside. If it is windy and rainy， the clothing will repeatedly slap the car paint， especially if the car blows sand on the clothes， it will draw many fine scratches on it. Because it will turn black over time. In addition， when the wind does not directly spray powder or clean the sand on the mechanism， but it should be washed with water， and prevent the sand particles on the paint surface from being scratched by the vacuum cleaner.
Always check the connections of the various parts of the hydraulic lift， and tighten them if they are loose. The tightness of the connecting bolts of the body should be checked when the body is under pressure.
Pay attention to check whether there are any broken wires and loose strands in the wire ropes of each part. If it exceeds the relevant regulations，HeilongjiangFixed lifting cargo elevator， it must be replaced immediately. The maintenance of the wire rope should be strictly in accordance with regulations.
The surface of the brushes of each part should be kept clean， and the pressure of the brushes should be adjusted so that the area is not less than %. Professional elevator factory， large quantity favorably， durable， safe and reliable.
The seat belt needs to be inspected every six months. The inspection load is kg， and the test time is five minutes. After the test， check whether the seat belt is cracked or deformed， and make a record of the experiment. Discontinue use immediately.
Whether it is used outdoors or indoors， some small problems will inevitably appear after a long period of time. At this time， what we should do is to maintain and maintain the elevator. How to follow the steps correctly It has become a difficult problem， and I will answer it with you.
device managementAs for the guide rail elevator installed outdoors， so special attention should be paid to regular maintenance and inspection to avoid accidents.
As for the guide rail elevator installed outdoors， it is often exposed to rain and sunlight， so special attention should be paid to regular maintenance and inspection to avoid accidents.
Precautions for using guide rail elevators Precautions for using guide rail elevators: It is strictly forbidden to overload， transport flammable and explosive products and other products.
It is strictly forbidden to switch the electric control switch with wet hands. Many people tend to ignore this detail. Although the safety voltage of the hydraulic lifting platform is below V if you touch the power supply with your hands， it may cause lifting failure in light cases， or electric shock accidents in severe cases.
Energy costsMany people think that the strength of the elevator itself is relatively high when using the elevator， but they do not know that this will cause increased wear and tear of the parts and inflexible operation， and pay attention to the work The installation precautions corresponding to the environment should not be ignored. Correct installation， use and maintenance of elevators are an important part of ensuring the normal operation of mechanical equipment. Therefore， when you install the elevator，HeilongjiangFactory lift cargo elevator， please be sure to strictly follow the installation and use related matters below， and assemble and use it carefully.
Working at heights is very common now and lifts are very popular in the market. Many high-level transportation tasks are completed by elevators， which are highly efficient and safe. However， attention should also be paid to the installation of the lift， otherwise there will be problems， and no one wants to see such a situation happen. What are the installation precautions for the lift?
Nowadays， small and medium-sized enterprises are holding products with the idea of good quality and favorable price.
HeilongjiangGuide rail lift (also known as freight elevator) is a non-scissor hydraulic lifting platform， which is mainly used in industrial plants， restaurants， restaurants， warehouses， docks， workshops and other places that need to move goods vertically between high-rise buildings above the second floor. The low height is especially suitable for sites where the site is not suitable for digging pits. What problems do we need to pay attention to in these places where elevators are used?
The wrong connection of the motor of the elevator When a coil， coil group or one-phase winding is reversed， it will cause a serious imbalance in the three-phase current and cause the winding to overheat.
Anti-corrosion measures for the body of aerial work vehicles Pay attention to small scratches. The paint surface of aerial work vehicles is often corroded. In addition to common collisions， scratches，HeilongjiangProfessional cargo elevator， small rocks on the driving tires， there may also be a peeling paint spot， and a small rust will appear after a long time. Because most of these scars are small， they are easy to ignore. Therefore， check regularly， the engine compartment cover and its surroundings， and once found， go to a professional beauty shop for processing.