Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.
Model Example: Hanging Cage Specification: LABSC/TDx Type I: ~ Type II: ~ Type V: ~ Technical Requirements: The load-bearing capacity of the foundation should be greater than P: P=(hanging cage weight+outer cage weight+total weight of guide rail frame+counterweight+load) x. (kN).
ZawelchBefore use， we should observe whether there is any damage to the electric elevator. We can conduct a no-load test to raise and lower it. If there are any damaged parts， they should be replaced in a timely manner to prevent major accidents.
The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
SongguwaThe net height of the landing door opening should not be less than m，ZawelchElectric elevator 5 meters， and the difference between the net width and the outlet width of the cage door should not exceed mm. When the floor door is closed， except for the gap between the lower part of the door that should not exceed mm， the size of any through-hole and opening related to the distance between any door and adjacent moving parts， as well as the gap around the door or between parts， should comply with the provisions of Table of "Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas" GB-.
The quality of the standard section should comply with the product manual and specification requirements.
Setting requirements: For construction electric elevators with foundations installed on roof slabs， floors， or other lower suspended structures， the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.
Protective measures should comply with regulatory requirements.
It is strictly prohibited to use travel limit switches as switches to stop operation.
During loading and unloading，ZawelchElectric lifting platform 2 meters，ZawelchElectric hydraulic elevator 15 meters， the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed mm.
Interpretation and observationWith the continuous improvement of urbanization level in China， the number of high-rise buildings in urban areas has sharply increased， and the height of buildings has also continued to grow. This has created a demand for high-altitude lifting platform vehicles. Therefore， in order to meet the needs of the domestic market and the public， efforts will inevitably be made to design and produce high-altitude lifting platform vehicles.
Before installation， the installation unit should confirm that the foundation， foundation bearing capacity， embedded parts， and foundation drainage measures of the installed construction electric elevator and auxiliary heavy equipment comply with the requirements of the special construction plan for the installation and dismantling of the construction electric elevator based on the construction electric elevator foundation acceptance form， concealed engineering acceptance form， and concrete strength report.
Principle of electric elevator rotary valve: When the electric elevator rises， the rotary valve will automatically open. To close the plug valve， it is necessary to first turn the handle to turn the plug to a degree position until it is closed， and then turn the transmission handwheel to lower the plug and achieve sealing.
Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends， oil pipe， and motor of the aluminum alloy electric elevator is good and whether there is any air leakage.
Then， and no deviation of one side is allowed. The lifting of goods does not allow people to stand on both sides of the platform， and the lifting of goods should try to maintain a stable and uniform speed.
ZawelchDuring loading and unloading the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed mm.
The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.
The motor of the hydraulic guide rail lifting platform is set around the wellbore， improving the utilization rate of the wellbore area.
